IBM SC30-3681-08 manual Syntax Load Local Remote, Local loadname, List view, Load local

Banks 2-3 contain load "vl/load-ver2.ldc" which uses 1652961 bytes

Loaded using TFTP over IP Filename loads/vl/load-ver2.ldc Host 128.185.210.125

Bank 4 contains load "vl/load-ver4.cfg" which uses 131084 bytes Loaded using TFTP over IP

Filename CONFIG Host 0.0.0.0

ªLoaded using TFTP over IPº implies that you used thecopy command to IBD from this local router.

view Displays the time, date, and other information about a scheduled image load.

Example:

list view

Time Activated Load Schedule Information...

The router is scheduled to reload as follows.

Date: April 1, 1997

Time: 13:00

Remote host IP address: 1.1.1.2

Via gateway: 0.0.0.0

Timeout in seconds: 10

Filename: /tftpboot/vl3.img

Interface address: 0

New address: 1.1.1.1

Network mask for this interface: 255.255.255.0

Load

Use the load command to copy the boot ®le into the device's main memory from either a local or remote source. The result of the load command is the same as performing the reload command from the * prompt.

Syntax:
load	local . . .
	remote . . .

local loadname

Retrieves a previously stored load image ®le from the device's IBD into the router's memory. The loadname must match one of the loadnames stored in the IBD. The loadname is case-sensitive.

To set up the IBD, use the add boot-entrycommand. This could take up to ®ve minutes.

You must have a load ®le in the IBD before you can use theload local command successfully.

Example:

load local

Loadname: ibd/softrel.ldc

Note: If the software does not ®nd the load ®le, then it will go into the boot monitor and do an auto-boot or manual boot, depending on the setting of your boot switch.

remote

Loads the boot ®le from a remote host into RAM. To perform a remote load:

1.Enter the load remote command after the Boot config> prompt and enter the remote host address, remote path name, ®rst hop address, and TFTP timeout value after the prompts.

104MRS V3.2 Software User's Guide