on
Reset
Use the reset command to clear the trace buffer and reset all associated counters.
Syntax:
reset
Set
Use the set command to configure tracing options.
Syntax:
set decode
default-bytes-per-pkt
disk-shadowing
max-bytes-per-pkt
memory-trace-buffer-size
stop-event
wrap-mode
exit
For an explanation of the set command, see “Set” on page198.
Subsystems
Use the subsystems command to activate tracing for the subsystems that support
packet tracing, or to display a summary.
Syntax:
subsystems atm
lec
summary
Example:
subsystems atm
Network number? 0
ATM Interface is selected
on | off | list [list]? on
Note that SVC uses VPI = 0, VCI = 5
and ILMI uses VPI = 0, VCI = 16
Beginning of VPI range [0]?
End of VPI range [0]?
Beginning of VCI range [0]? 16
End of VCI range [0]? 16
Tracing event ATM.88: ATM frames
Example:
subsystems lec
Network number? 1
ATM Emulated LAN is selected
on | off | list [list]? on
Trace which types of frames (data, control, both) [both]?
Tracing event LEC.11: data frames over ATM Forum LEC: interface 1
ELS Monitoring Commands (Talk5)
206 MRS V3.2 Software User’s Guide