Enter maximum number of active links (2 - 23): [2] 3

Set Call Direction (Inbound, Outbound, Both): [Inbound] Inbound

Enter Idle timer (seconds, 0 means always active) (0 - 65535): [0] 0

3.Next you are prompted to add/edit the ISDN dial-circuits that can be used by the MP interface. The example below demonstrates adding one dial-circuit but you may add more than one dial-circuit per MP interface. Choose to add a dial-circuit by selecting the last number in the list denoted by ²New Circuit² or to edit an existing dial-circuit con®guration by typing its corresponding number. (Note: The example below does not display any existing dial-circuit con®guration.)

Current Dial Circuit Configuration:

Num

Intf# Intf Type

BaseIntf# MP Direction Destination

1

New Circuit

 

Choose a Dial Circuit Link you wish to edit/add: (1 - 1): [1]

Enter interface # of Base Net, "?" for List,"Q" to quit: (6)

Address assigned name

Network Address

Network Subaddress

---------------------

---------------

------------------

default_address

9999999

 

Assign Line ID *In* Network Address:

 

Network Address name ([1-23] chars): LID_IN

 

Enter Network Address [1-26 digits]: 1234

 

Enter Network Subaddress [0-21 digits]:

 

Interface #:

8

 

Interface Type:

PPP Dial Circuit

 

Base Intferface #:

6 (ISDN Base Net)

 

Multilink PPP Interface #: 7

 

Call Direction:

Inbound only

 

Destination Name:

default_address

 

Line ID *IN* Name:

LID_IN

 

Is this correct (Yes, No): [Yes] Yes

Add another Dial Circuit Link (Yes, No): [Yes] No

4.Next, the MP interface and all of the dial-circuits for the interface are listed for con®rmation. In this case, there is only one dial-circuit for the MP interface.

Multilink PPP Interface #: 7

 

Call Direction:

Inbound only

Idle timer:

0

(fixed circuit)

Maximum Number of links:

3

 

Dial Circuit Link

 

 

Interface #:

8

 

Interface Type:

PPP Dial Circuit

BASE Interface #:

6

(ISDN Base Net)

Destination Name:

default_address

Line ID *In* Name:

LID_IN

Is this correct (Yes, No): [Yes] Y

5.To add/edit another MP interface type y to the following question. Answering n will exit you from the MP con®guration section.

Add another Multilink PPP Interface (Yes, No): [Yes] n

6.After con®guring all of the MP interfaces, an MP con®rmation question will appear with all of the con®gured MP interfaces listed. You can type y to save the changes or n to discard the new MP con®guration.

656MRS V3.2 Software User's Guide

Page 692
Image 692
IBM SC30-3681-08 manual Lidin