What to do when these messages are displayed
Message | Cause (Details) |
No Signal
No device is connected to the [DVI] terminal.
The
NInput the video signals.
Out Of Range
A video signal that cannot be used with this unit has been input.
NInput 1080/50p or 1080/60p video signals.
not available
Upon pressing the [ZOOM T/W] or [FOCUS
NSet AZoom/FocusB of the AOptionsB menu to AUnlockB.
|
|
|
|
| At the moment when the accumulated lamp time |
|
|
|
| ||
|
|
|
|
| reaches 1900 hours, a ALamp replacementB message |
|
|
|
|
| will be displayed. |
|
| Lamp replacement |
| ||
|
|
|
|
| In addition, when the accumulated lamp time reaches |
|
|
| EXIT |
| between 1900 hours to 2000 hours, the (Lamp |
|
|
|
|
| replacement) message will be displayed each time the |
|
|
|
|
| projector is turned on. |
|
|
|
|
| ● The message can be cleared by pressing any button on |
|
|
|
|
| the remote control or this unit. |
|
|
|
|
| NGet ready a new lamp (lamp unit) in advance or |
|
|
|
|
| replace as soon as possible. |
|
|
|
|
|
|
|
|
|
|
| The ALamp replacementB message will be displayed |
|
|
|
|
| |
|
|
|
|
| and the AWarningB word appears blinking when the |
|
| Lamp replacement |
|
| |
|
|
|
| accumulated lamp time exceeds 2000 hours. | |
|
|
|
|
| |
|
| Warning |
| The message can be cleared by pressing the [EXIT] | |
|
|
| EXIT |
| button. However, the same message will reappear every |
|
|
|
|
| hour. |
|
|
|
|
| When the accumulated lamp time exceeds 2000 hours, |
|
|
|
|
| the unit cannot be turned on again once it is switched to |
|
|
|
|
| the standby mode or turned off. |
|
|
|
|
| If continuous projection is performed after 2000 hours, |
|
|
|
|
| the unit will shut down upon exceeding 2010 hours and |
|
|
|
|
| projection will be disabled. |
|
|
|
|
| NInstall a new lamp (lamp unit) and reset the lamp time. |
|
|
|
|
| (A Pages 35 - 38) |
|
|
|
|
|
|
40
