IBM SC30-3681-08 manual Syntax Parameters, Example parameters

Con®guring V.34

Duration

Length of time that the circuit has been in the current state.

Parameters

Use the parameters command to display the current V.34 serial line con®guration. Note that this is the same information displayed in the V.34 Config> list command.

Syntax:

parameters

Example: parameters

V.34 port Parameters
Local Network Address Name	= v402
Local Network Address	= 1-508-898-2402
Non-Responding addresses:
Retries	= 1
Timeout	= 0 seconds
Call timeouts:
Command Delay	= 0	ms
Connect	= 0	seconds
Disconnect	= 0	seconds
Modem strings:
Initialization string	= at&f&s1l1&c1x3

Local Network Address Name:

Network address name of the local port.

Local Network Address:

Network dial address of the local port.

Non-responding addresses:

Retries

Maximum number of calls the router attempts to make to a non-responding address during the timeout period.

Timeout

If the router reaches the maximum number of retries to a non-responding address, it does not attempt to establish the call until this time has expired. This timeout period begins when the router attempts the ®rst call to an address.

Call timeouts:

Command Delay

Amount of time, in milliseconds, that the router waits to initiate or answer a call after it turns on DTR (Data Terminal Ready). If you set this parameter to 0, the router waits for the modem to respond to DTR with the CTS (Clear to Send) signal before it issues commands.

Connect

Number of seconds allowed for a call to be established. If this parameter is set to 0, the modem controls the connection establishment timeout.

Disconnect

After the routers drops DTR it waits this amount of time before it

Con®guring V.34 605