IBM SC30-3681-08 manual IP-Encapsulation for Ethernet ATM Forum-Compliant LEC only, QoS

Con®guring Forum LE Clients

This function of the device is not changed whether source routing is enabled or disabled. The default setting is enabled.

Some stations cannot properly receive frames with Source Routing RIF on them. This is especially common among NetWare drivers. Disabling source routing in this situation will allow you to communicate with these stations.

Source routing should be enabled only if there are source-routing bridges on this ring through which you want to bridge IP, IPX, and AppleTalk Phase 2 packets. Source routing must also be enabled so that LLC test response messages can be returned.

Syntax:

source-routingenable

disable

Example:

source-routing disable

IP-Encapsulation (for Ethernet ATM Forum-Compliant LEC only)

Use the IP-encapsulationcommand to select Ethernet (Ethernet type X'0800') or IEEE 802.3 (Ethernet 802.3 with SNAP). Specify either type Ethernet or IEEE-802.3.

Syntax:

IP-encapsulationEthernet

IEEE-802.3

List

Use the list command to list the LE client con®guration.

Syntax:

list

QoS

Use the qos-con®gurationcommand to get you to the LEC QoS Config> prompt from which you can con®gure Quality of Service as described in LE Client QoS Con®guration Commands inUsing and Con®guring Features.

Syntax:

qos-con®guration

Set

Use the set command to set LE Client parameters.

Syntax:

298MRS V3.2 Software User's Guide