IBM SC30-3681-08 Chapter 42. Conguring and Monitoring the V.25bis Network

Chapter 42. Configuring and Monitoring the V.25bis Network
Interface
This chapter describes the V.25bisconfiguration and operational commands and
GWCON commands. It includes the following sections:
v“Accessing the Interface Configuration Process”
v“V.25bisConfiguration Commands”
v“Accessing the Interface Monitoring Process” on page587
v“V.25bisMonitoring Commands” on page 587
v“V.25bisand the GWCON Commands” on page 592
Accessing the Interface Configuration Process
Use the following procedure to access the V.25bisconfiguration process.
1. At the OPCON prompt, enter the talk command and the PID for CONFIG. (For
more detail on this command, refer to Chapter 3. The OPCON Process.) For
example:
*talk 6
Config>
After you enter the talk 6 command, the CONFIG prompt (Config>) displays on
the console. If the prompt does not appear when you first enter CONFIG, press
Return again.
2. At the CONFIG prompt, enter the list devices command to display the network
interface numbers for which the router is currently configured. For example:
Config> list devices
Ifc 0 Ethernet CSR 81600, CSR2 80C00, vector 94
Ifc 1 V.25bis CSR 81620, CSR2 80D00, vector 93
Ifc 2 WAN X.25 CSR 81640, CSR2 80E00, vector 92
Ifc 3 WAN PPP CSR 381620, CSR2 380D00, vector 125
Ifc 4 WAN Frame Relay CSR 381640, CSR2 380E00, vector 124
Ifc 5 Token Ring CSR 600000, vector 95
3. Record the interface numbers.
4. Enter the CONFIG network command and the number of the interface you want
to configure. For example:
Config> network 1
V.25bis Config>
The V.25bisconfiguration prompt now displays on the console.
V.25bis Configuration Commands
Table75 on page 584 summarizes and the rest of the section explains the V.25bis
configuration commands. These commands allow you to display,create, or modify a
V.25bisconfiguration. Enter the V.25bis configuration commands at the V.25bis
Config> prompt.
© Copyright IBM Corp. 1994, 1998 583