IBM SC30-3681-08 Conguring Isdn Parameters, Configadd isdn-address, Isdn Configset switch net5

Using ISDN

vNetwork Subdial Address. Optional. This is an additional part of telephone number, such as an extension, that is interpreted once the interface connects to a PBX. You can enter up to 20 numbers, as well as 11 additional spaces and punctuation. The router uses only the numbers.

To add an ISDN address, enter the add isdn-addresscommand at the Config> prompt. For example:

Config>add isdn-address

Assign address name [23] chars []? baltimore

Assign network dial address [1-15 digits] []? 1-555-0983

Assign network subdial address [1-20 digits] []? 23

To see a list of your ISDN addresses, enter list isdn-addressat the Config> prompt.

To delete an ISDN address from your list, enter the delete isdn-addresscommand at the Config> prompt.

Con®guring ISDN Parameters

Access the ISDN Config> prompt. To access the ISDN Config> prompt, enter the

network command followed by the interface number of the ISDN interface at the Config> prompt. For example:

Config>network 3

ISDN user configuration

ISDN Config>

You can use the list devices command at the Config> prompt to display a list of interface numbers con®gured on the router. See ªISDN Con®guration Commandsº on page 627 for more information about con®guration commands.

1. Specify the type of switch/service to which this ISDN interface is connected.

Use the set switch-variantcommand to specify the type of switch to which this ISDN interface is connected. See ªSwitches/Services Supportedº on page 618 for the list of switches/services. For example:

ISDN Config>set switch net5

This is the software type running at the switch (for example, DMS100 means running DMS100 Custom software).

2. Specify the network address name of the local port.

Use the set local-address-namecommand to specify the network address name of the local port. You must use one of the address names you de®ned using the add isdn-addresscommand. For example:

ISDN Config>: set local-address-name

Assign local address name []? baltimore

Note: This is what we will send in the Calling Party Number ®eld of the ISDN

Setup message.

3.Set the directory number of the local port.

DN0 is what the ISDN service provider is placing in the Called Party Number ®eld in an ISDN setup message. This ®eld is used for incoming calls only. If no DN0 is con®gured, the router will answer any call made to it without checking the DN0 ®eld. If you have added a DN0 ®eld, you must use theremove dn0 command to remove it. You cannot just blank it out with another set command.

ISDN Config>set dn0

Enter DN0 (Directory-Number-0) [ ]?15550983

620MRS V3.2 Software User's Guide