IBM SC30-3681-08 manual Service-prole-id B-channel# spid#, Timeout-call-address # of seconds

ISDN Con®guration Commands

maximum number of calls the router attempts to make at one time. Setting
retries-call-addressto 0 causes the router to bring up all circuits at once.
If you set the switch-variant to INS64, you cannot change
theretries-call-addressdefault. It is ®xed at 2.
Valid Values: 0 to 30
Default Value: 23 (2 for BRI)
service-pro®le-id B-channel# spid#
For BRI only. Sets the service pro®le ID (SPID) for each B-channel. SPIDs
are used in the United States to uniquely identify a particular ISDN device.
This ID is a number up to 20 digits long and is assigned by ISDN service
providers. SPIDs are used predominantly in a multipoint bus con®guration
where multiple ISDN devices share a single ISDN line. Check with your
service provider to determine whether or not you are required to use a
SPID.
Example:
	set spid
	Enter B-Channel Number [1]? 1
	Enter Service Profile ID (SPID) [123]? 91955555550100
timeout-call-address # of seconds
After the router reaches the maximum number of retries-call-addressto a
non-responding address, it does not make further calls to that address until
this time has expired. The timeout period begins when the router attempts
the ®rst call to an address. Settingtimeout-call-addressto 0 causes the
router to retry until the call is established.
If you set the switch-variant to INS64, you cannot change
timeout-call-address. It is ®xed at 180.
Valid Values: 0 to 65535 seconds
Default Value: 180 seconds
Example:
	set timeout-call-address
	Outbound call address Time-out (secs) [0]? 180
switch-variant
Speci®es the model of the switch to which this ISDN interface is connected.
You can choose switch-variants/service type for the ISDN Basic Rate
interface or the ISDN Primary Rate interface from the following lists.
Valid Values Basic Rate Interface (BRI):
v	AT&T 5ESS (North America)
v	DMS100 (North America)
v	USNI1 (North America National ISDN1)
v	USNI2 (North America National ISDN2)
v NET 3 (European ETSI)
v	INS 64 (Japan)
v	VN3 (France Telecom)
v AUS TS 013 (Australia)
v	Native I.430

Default Value: NET 3

Valid Values ISDN Primary Rate Interface (PRI)/Channelized T1/E1:

632MRS V3.2 Software User's Guide