IBM SC30-3681-08 manual Reset, Statistics

GWCON Process

Due to the scheduling algorithms of the router, the dynamic numbers of Curr (particularly the Input Queue Curr) may not be fully representative of typical values during packet forwarding. The console code runs only when the input queues have been drained. Thus, Input Queue Curr will generally be nonzero only when those packets are waiting on slow transmit queues.

Reset

Use the reset command to disable the speci®ed interface and then re-enable it using new interface, protocol and feature con®guration parameters. See ªResetting Interfacesº on page 47 for more information.

Syntax:

reset interface#

Statistics

Use the statistics command to display statistical information about the network software, such as the con®guration of the networks in the router.

Syntax:

statistics interface#or range_of_interface#

To display information about multiple interfaces, specify the range_of_network# (or

a combination of interface# and range_of_interface#). For example, specifying statistics 0 3 25-50displays the information for nets 0, 3, and 25 through 50.

To display information about one interface only, enter the interface or network number as part of the command. To obtain the interface number, use the GWCON con®guration command.

Example:

statistics		Unicast	Multicast	Bytes	Packets	Bytes
Nt	Interface	Pkts Rcv	Pkts Rcv	Received	Trans	Trans
0	Eth/0	137	1	8832	1068	65297
1	PPP/0	0	0	0	0	0
2	PPP/1	0	0	0	0	0

Nt Network interface number associated with the software.

Interface

Type of interface.

Unicast Pkts Rcv

Number of non-multicast, non-broadcast speci®cally-addressed packets at the MAC layer.

Multicast Pkts Rcv

Number of multicast or broadcast packets received.

Bytes Received

Number of bytes received at this interface at the MAC layer.

Packets Trans

Number of packets of unicast, multicast, or broadcast type transmitted.

Chapter 10. The Operating/Monitoring Process (GWCON - Talk 5) and Commands 141