SDLC Relay Configuration Commands
This section summarizes the SDLC Relay configuration commands. Both the
network and protocol parameters for SDLC relay are documented in this chapter.
The SDLC Relay configuration commands allow you to specify router parameters
for interfaces transmitting SDLC Relay frames. Restart the router to activate the
configuration commands. Table66 shows the commands for both the network sdlc
and protocol sdlc.
Table66. SDLC Relay Configuration Commands Summary
Command Network
SRLY Protocol
SDLC Function
? (Help) yes yes Lists all of the SDLC Relay configuration
commands or lists the options associated with
specific commands.
Add yes Adds groups, local ports, and remote ports.
Delete yes Deletes groups, local ports, and remote ports.
Disable yes Disables groups and ports.
Enable yes Enables groups and ports.
List yes yes Displays entire SDLC Relay and group specific
configurations.
Set yes Sets the link parameters and remote station
parameters.
Exit yes yes Exitsthe SDLC Relay configuration environment
and returns to the CONFIG environment.
Add
Use the add command to add group numbers, local ports, and remote ports.
Syntax:
add group
group#
local-port
remote-port
group Assigns a number to a group of primary or secondary ports added to the
router.
Example: add group
Group number: [1]? 1
Group number
The group number that you are designating for the port.
local–port
Identifies the interface that you are using for the local port.
Example: add local–port
Group number: [1]? 1
Interface number: [0]? 2
(P)rimary or (S)econdary:[S]? p
Group number
The group number for the port. This number must match one of the
add group parameters configured previously.
Configuring and Monitoring SDLC Relay
526 MRS V3.2 Software User’s Guide