5250 REMOTE EMULATOR CARD
If you have tried all of the above solutions and the emulator is still not active, press the DOS Enter key. This will cause a red error code to appear in the bottom left corner of the display. Refer to the error code chart in Table
Table 9-1. Error Codes.
SRC | Description | Possible Causes(s) |
|
|
|
0040 | It has been at least thirty seconds | a. The modem is not powered on. |
| since any valid SDLC frame has | b. The telephone connection |
| been received for any address, and | between the modems/DCEs is |
| it has also been at least 30 seconds | down. |
| since the DSR signal has been | c. The modem cable is bad or is |
| present on the cable from the | not corrected properly. |
| modem/DCE. | d. The Controller is connected to |
| This code indicates conditions | a modem/DCE with a null- |
| that would normally result in either | modem |
| error code 0055 or error code 0056, | is directly connected to the host |
| but gives the additional information | with |
| that DSR is not present. | cable. |
|
| e. Modems are configured |
|
| incorrectly. |
|
|
|
0049 | Software has detected that the | The MPIC is defective or not |
| MPIC | installed correctly. The software |
| has functioned in an invalid | did not get the interrupt from the |
| manner. | card, there is an I/O problem, or |
|
| the board is bad. |
|
|
|
81