Black Box Remote Emulator Card, 5250 Quick Setup Guide, Unpacking, 2.2Installing the Hardware

5250 REMOTE EMULATOR CARD

2. Quick Setup Guide

Thank you for buying the 5250 Remote Emulator Card. If you are familiar with emulation equipment, this chapter is designed to help you get up and running in a short amount of time. It describes how to do the hardware installation, software installation, and configuration setup in just a few steps each.

CAUTION!

The 5250 Remote Emulator Card is a static-sensitive device. Keep the Card in its protective bag until you are ready to install it.

2.1 Unpacking

Check the package your Card was shipped in for water-related or shipping- related damage; contact the carrier if you find any. The package should contain the following:

•(1) 5250 Remote Emulator Card

•(1) 3.5" software diskette

•(1) copy of this manual

Keep the original packaging in case you ever have to reship the card. If your system requires 5 1⁄4" diskettes, contact your supplier.

2.2Installing the Hardware

1.Turn OFF the PC and any peripherals that might be attached to it. Unplug the PC’s power cord or power supply from the electrical outlet and (if possible) from the PC.

CAUTION!

Make sure that the PC is OFF and its power supply is unplugged and (if possible) its power cord removed before you begin installing the Card or connecting any of its cables. Don’t turn the PC back ON until you have completely finished installing the Card and connecting all of its cables.

11