Black Box 5250, Remote Emulator Card manual Warnung, Possible Settings of the Card’s DIP Switch

5250 REMOTE EMULATOR CARD

WARNUNG!

Vergewisseren Sie sich, dass die PC ausgeschaltet und die Netzzuleitung entfernt ist bevor irgendwelche Kabel angeschlossen werden. Schalten Sie Gerät nicht wieder ein bevor alle Kabel angeschlossen sind. Zur vollständigen Trennung vom Netz ist der Netzstecker zu ziehen.

2.Disconnect the PC from its monitor and remove the PC’s cover. Locate an empty expansion slot and remove the slot’s cover (but keep the slot cover’s screw close by). Touch a grounded surface, other than the PC’s chassis to dissipate any static charge you might have built up, then carefully remove the 5250 Remote Emulator Card from its anti- static bag.

3.Grasp the 5250 Remote Emulator Card by its edges. If the Card’s factory-default I/O address 300 to 30F is available in your PC, go to Step 4. Otherwise, using a screwdriver, set the Card’s DIP switch for an unused I/O address (see Table 2-1 below).

Table 2-1. Possible Settings of the Card’s DIP Switch

Base I/O	Switch-Position Number
Address Used	1	2	3	4
300 to 30F*	ON	ON	ON	ON
310 to 31F	ON	ON	ON	OFF
320 to 32F	ON	ON	OFF	ON
340 to 34F	ON	OFF	ON	ON
350 to 35F	ON	OFF	ON	OFF
360 to 36F	ON	OFF	OFF	ON
380 to 38F	OFF	ON	ON	ON
3A0 to 3AF	OFF	ON	OFF	ON

*Factory-default setting

4.Press the card firmly into the expansion slot. Screw the slot cover’s screw back in.

5.Run the Card’s diagnostic program before you replace the PC’s cover:

a)Plug in the monitor, keyboard, and power without replacing the PC’s cover, then turn ON the PC. (Be extremely careful while you do this.)

b)At the first DOS prompt, go to the directory where you have the 5250 Remote Emulator Card’s software stored: Type the diskette-

12