Enterasys Networks Fast Network 10 manual Changing a Community Name, Setting the Baud Rate

Chapter 4: Monitoring and Managing Your FN10

4.5.4 Changing a Community Name

A community name is similar to a password. You use the same steps to assign a new community name or to change an existing community name. This sets the MIB variable sxadminAnyPass. You can then enter a community name to perform any SNMP sets.

To assign a community name, at the LCM prompt:

1.Type community

2.Enter the old community name.

If one has not been assigned, you do not need to enter anything. LCM prompts you for the new community name.

3.Enter the new community name.

LCM prompts you to verify the new community name by retyping it.

4.Retype the new community name.

4.5.5 Setting the Baud Rate

You can set the baud rate for your LCM console connection. The options for baud rate include:

•1200

•2400

•4800

•9600

•19200

The default rate is 9600.

NOTE

Make sure that the baud rate you set matches the baud rate setting for the terminal you are using.

Page 4-18 Fast Network 10 User Guide