Enterasys Networks Fast Network 10 manual Help, Erase

Chapter 1: Introduction

1.6.2.1 Help

Displays the menu of available commands. Help can also be displayed by typing a question mark (?). The output from the help command is displayed below.

FN10 > help

FN10 Local Console Manager

help or ?

status [PORT-RANGE] baud [BAUD-RATE] exit or logout erase

ident

ipaddr [PORT# IPADDR [MASK]] addresses display [any] [ADDR [MASK]] bridge [PORT-RANGE [OPTIONS]]

trunk [PORT-RANGE [{on off}]] enable [PORT-RANGE [noRIP]] disable [PORT-RANGE]

filters {displaymodifyadddelete} community

sttimer [TIME-VALUE]

workgroup [NAME [deletePORT-RANGE [INFO]]] speed [PORT-RANGE [{10100}]]

reboot {SECONDS off} arp [display]

route display [IPADDR] traplog

this menu

to display unit or port status to change the console baud rate to logout

to erase configuration information to display unit identification

to set or display IP addresses to display learned addresses to set bridging methods

to set or display trunking status to enable a set of ports

to disable a set of ports to manage port filters

to change the password/community name to set or display st age time

to set or display workgroups to set or display Fast Ethernet speed to reboot the unit after seconds

to display arp table information

to display routing table information to display the most recent SNMP traps

FN10 >

1.6.2.2 Erase

Entering erase to erase the current FN10 configuration sets up the IP address on Port 1 to 192.0.2.1 (default) when the FN10 is rebooted.

Page 1-18 Fast Network 10 User Guide