5250 REMOTE EMULATOR CARD
Table 9-1 (continued). Error Codes.
SRC | Description | Possible Causes(s) |
|
|
|
0099 | There is no SNA session active for | In many cases, when this error |
| the display station. Normally, this | code appears, it will be replaced in |
| means that the display station or its | about 30 seconds with one of the |
| remote controller is varied off, and | previous seven |
| the screen is blank. | error codes. If this happens, the |
|
| new error code will be more |
|
| specific, and should be used to |
|
| determine the problem. If error |
|
| code 0099 is not replaced, the |
|
| problem might be: |
|
| a. The display station has been |
|
| varied off at the host, though its |
|
| remote controller is varied on. |
|
| b. The display station is not |
|
| configured on the host, or its |
|
| twinax address (0 through 6, |
|
| local station address) is |
|
| configured incorrectly. |
|
|
|
Emulator drops off line and will not come back up or stays at a “Vary on pending” status.
Cause: Interference on telephone line.
Action: Have the phone company check the telephone line.
Cause: Message on console.
Action: Answer, then delete, the message.
Cause: Modem or emulator “locked up.”
Action: Power OFF, then power ON both modems and/or the emulator.
86
