5250 REMOTE EMULATOR CARD
Graphics characters or blinking characters appear on the screen.
Cause: 5250 Remote Emulator Card not seated properly.
Action: Unplug the PC, open it, and check the installation of the 5250 Remote Emulator Card.
Cause: I/O-address conflict.
Action: Check the addresses of all other cards in the PC (referring to those cards’ manuals if necessary). If one of the other cards is using the same address as the 5250 Remote Emulator Card, you must change one of the two cards’ addresses.
Cause:
Action: Make sure the
in the 5250 Remote Emulator Card’s software match (see Section 6.2.1).
Improper keystrokes or no keystrokes appear on the screen.
Cause: PC’s keyboard loose or unplugged.
Action: Make sure the keyboard cable is tightly connected at both ends.
Cause: Host inhibited.
Action: Check the II indicator on the host session’s status line.
Cause: Wrong keyboard emulation.
Action: Make sure the right keyboard emulation (PC or 5250) is selected in the 5250 Remote Emulator Card’s configuration (see Section 6.2.2).
Cursor appears at the top left corner of the screen when emulation starts.
Cause: Invalid station address.
Action: Check the station addresses on the host and in the 5250 Remote Emulator Card’s configuration (see Section 6.2.1).
Cause: Unanswered messages at the host.
Action: Check the host console for unanswered messages.
77
