Black Box 5250, Remote Emulator Card manual Specifications, System Hardware Requirements

5250 REMOTE EMULATOR CARD

	1. Specifications
System Hardware
Requirements —	PC: IBM PC, PC/XT, AT, or 100% compatible w/ free
	16-bit ISA- or EISA-bus slot and 3.5" diskette drive;
	Host: IBM System/3X or AS/400 with an available
	synchronous communications port that supports
	the SDLC protocol;
	DCE (for remote operation only): (1) Pair of sync
	modems with appropriate DTE-to-DCE cables
System Software
Requirements —	PC: DOS 3.3 or higher;
	System/34 Host: System/34 release 9.0;
	System/36 Host: System/36 release 5.1 or higher;
	System/38 Host: System/38 release 8.0 or higher;
	AS/400 Host: OS/400 V2R0 or higher
System Memory
Requirements —	PC: 225 KB + 11 KB per display session + 29 KB
	per printer session; might require an additional
	16 KB to save 132-column graphic screens when
	hotkeying between host and DOS sessions
Bus —	16-bit ISA or EISA; not compatible with
	Micro Channel Architecture (MCA)
Address Used —	Either 300 to 30F, 310 to 31F, 320 to 32F, 340 to 34F,
	350 to 35F, 360 to 36F, 380 to 38F, or 3A0 to 3AF
	(user-selectable)

Interrupts Used — Either IRQ3, IRQ4, IRQ10, IRQ11, or IRQ15 (user-

	selectable)
Cable Required —	For local operation:
	(1) 20-ft. (6.1-m) cross-pinned adapter cable:
	Under EIA RS-232D/CCITT V.24: (1) DB44 male
	to DB25 female (EHN064-0020);
	Under CCITT X.21: (1) DB44 male to DB15
	female (EHN063-0020);
	Under CCITT V.35: (1) DB44 male to 34-pin
	M-block male (EHN065-0020);

For remote operation:

(1)20-ft. (6.1-m) straight-thru-pinned adapter cable: Under EIA RS-232D/CCITT V.24: (1) DB44 male

to DB25 female (EHN061-0020);

8