Fujitsu MAP3147, MAP3367 Eer Per Dte Dcr, Mode Select parameters verify error recovery parameters

Parameter Data Formats

	Bit	7	6	5		4		3	2	1	0
Byte
0		0	0	0	0		0		1	1	1
1					X‘0A’ (Page Length)
2			(Reserved)					EER	PER	DTE	DCR
	Default	0	0	0		0		1	0	0	0
	Variable	0	0	0		0		1	1	1	1
3				Number of retries during VERIFY.
	Default						X‘3F’
	Variable						X‘FF’
4					Correctable Bit Length
	Default					X‘E9’ (=233 bits)
	Variable						X‘00’
5-9					X‘0000000000’ (Reserved)
10-11					Recovery Time Limit
	Default						X‘7530’
	Variable						X‘FFFF’

Figure 4.5 MODE SELECT parameters: verify error recovery parameters

(See the Note.)

The error recovery parameters divided in this page descriptor are applicable for the following commands.

•VERIFY

•WRITE AND VERIFY (verify operation)

Note:

If selecting the SCSI-1/CCS mode in the CHANGE DEFINITION command specification, use Page code = 1 (Read/Write Error Recovery Parameters) instead of this parameter.

a.Error recovery flags

•EER (enable early recovery)

•PER (post error)

•DTE (disable transfer on error)

•DCR (disable correction)

The definitions and functions of these control flags are the same as for the read/write error recovery parameters. See item (1) concerning the details.

4 - 20 C141-E167