Fujitsu MAS3735, MAP3367, MAP3147, MAP3735, MAS3367 specifications Parameter length

3.4 Maintenance, Diagnostic Commands

3.When a command other than the RECEIVE DIAGNOSTIC RESULTS command is linked to this command, the execution results (response data) may no longer be secure.

Header

Page Parameter

		Bit		7		6	5	4	3	2	1	0
	Byte
	0							Page Code
	1			0	0		0	0	0	0	0	0
	2						Page Parameter Length (MSB)
	3						Page Parameter Length (LSB)
	4
													~
~			~		Parameter
~			~										~
	n

Figure 3.18 SEND DIAGNOSTIC command: parameter list configuration

•Page code

This field specifies the code which identifies the type of parameter page being transferred from the INIT and the operation that should be executed. The parameter pages which can be specified by the INIT and their functions are as shown below.

Page Code (Hex)

Function

00

Reports a list of the supported page codes.

40

Logical/Physical Address Conversion

•Page parameter length

This field specifies the byte length of the page parameter after byte 4. The INIT must specify the same value as the length specified for each of the parameter pages, which will be explained later.

•Page parameter

This field specifies each of the inherent parameters in each page code. Depending on the page code, this field may not be necessary (page parameter length = 0).

a. Page code list

C141-E167 3 - 95