Fujitsu MAS3367, MAP3367, MAP3147, MAS3735, MAP3735 specifications SET Limits 33 Not Supported

Command Specifications

This command executes a seek operation of the cylinder/track where the logical data block specified in the "Logical block address" field in the CDB exists.

The functions and operation of this command are the same as those of the Group 0 SEEK command (Section 3.2.7), except that it is possible to specify 4-byte logical block addresses.

3.2.9SET LIMITS (33) (Not Supported)

	Bit	7	6	5		4		3	2	1	0
Byte
0							X‘33’
1			LUN			0	0		0	RdInh	WrInh
2				Logical Block Address (MSB)
3					Logical Block Address
4					Logical Block Address
5				Logical Block Address (LSB)
6		0	0	0	0		0		0	0	0
7				Transfer Block Count (MSB)
8				Transfer Block Count (LSB)
9		0	0	0	0		0		0	0	Link

This command specifies the address range of logical data blocks on an ID which it is possible to access by commands which follow this command and which are linked to it, and to specify the type of operations which it is possible to execute. It is possible to issue this command once only in a group of commands which are linked in a series.

Note:

The specifications in this command are valid only for a series of linked commands which follow this command. When the link between the commands is cut, the specifications in this command lose their validity.

The "Logical block address" field in the CDB specifies the logical block address which is the staring point of the range where access is permitted. When an address in the User Space (X '00000000' or higher) is specified in the "Logical block address" field, access to the User Space only is permitted in linked commands which follow this command and CE space cannot be accessed. On the other hand, if an address in CE space (X '80000000' or higher) is specified, access to CE space only is permitted in linked commands which follow this command, and User Space cannot be accessed.

3 - 72 C141-E167