Fujitsu MAP3735, MAP3367, MAP3147, MAS3735, MAS3367 specifications Command Specifications

Command Specifications

g.Supported functions

The bit positions shown below are valid only when the CHANGE DEFINITION command is set so that the SCSI-2 or SCSI-3 mode INQUIRY data are transferred, and the functions which the IDD supports are shown in the bit correspondence.

"1" indicates that that function is supported and "0" indicates that that function is not supported. When the CHANGE DEFINITION command is not set so that SCSI-2 mode INQUIRY data are transferred, "0" is displayed in all these bit positions.

• SCSI-3 mode

[Byte 3]
- AERC (Asynchronous event reporting capability):
Asynchronous condition notify function			[0]
- NORMACA (Normal ACA supported):
ACA support			[0]
- HISUP (Hierarchical support):
Defined the hierarchical addressing model to assign LUN			[0/1]
[Byte 5]
- SCCS (SCC support):
Embedded storage array controller equipment			[0]
[Byte 6]
- BQue (Basic queuing):
Combination with CMDQUE			[0]
- EncServ (Enclosure service):
Enclosure service			[0]
- MultiP (Multi port):
Supported multi-port			[0]
- MChngr (Medium changer):
Medium Changer			[0]
- Addr16 (Wide SCSI address 16):
16 bit SCSI addressing			[0/1]
[Byte 7]
- RelAdr (Relative addressing):
Relative logical block addressing			[0]
- WBus16 (16-bit wide data transfer):
Data transfer on a 2-byte bus			[0/1]
- Sync (Synchronous data transfer):
Data transfer on the synchronous mode			[1]
- Linked (Linnked command):
Command link function			[1]
- TranDis (Transfer disable):
Continue task and target transfer disable message			[0]
- CmdQue (Command queuing):
Command queuing function			[1]
Bque	CmdQue	Description
0	0	No command queuing of any kink supported

01 Command queuing with all types of task tags supported

10 Basic task set model supported

11 Illegal combination of BQue and CmdQue bits

-VS (Vendor specific):

Not defined [0]

3 - 6 C141-E167