Fujitsu MAP3147, MAP3367, MAS3735, MAP3735, MAS3367 specifications Sense and subsense codes 2

				5.1 Sense Data
		Table 5.2		Sense and subsense codes (2 of 5)
C*	Q*	Name		Explanation	Sense
					key
13	00	Sync Byte not found for	SB (Sync Byte) could not be detected in the Data area.		1, 3, B
		Data field
14	00	Record entity not found	Expected data from a sector was undetected. (LBA compare error		1, 3, B
			detected by FMT)
	01	Record not found	The target data block (sector) could not be detected.		3, B
15	01	Mechanical positioning	A seek error occurred in the drive.		1, 3, B
		Error
	02	Positioning Error detected	LBA did not match due to Cylinder number’s mismatch.		1, 3, B
		by read of medium
17	01	Recovered data with retries	A data error was recovered from by reading was retried.		1
	02	Recovered data with	A data error was recovered by read retry with offsetting head to		1
		positive head offset	positive direction.
	03	Recovered data with	A data error was recovered by read retry with offsetting head to		1
		negative head offset	negative direction.
	06	Recovered data without	Automatic alternate allocation was applied without ECC correcting a		1
		ECC: data auto-	data error.
		reallocated
	08	Recovered data without	Rewriting to the same sector was performed without ECC correcting		1
		ECC: recommended	a data error.
		rewrite
19	02	Defect list error in primary	An error was detected during reading of the defect list (P List).		3
		list
	03	Defect list error in grown list	An error was detected during reading of the defect list (G List).		3
	80	Log information read error	An error was detected during reading of statistical information.		3
	81	Log information write	A write error was detected during writing of statistical information.		3
		error
	82	Drive Parameter SA read	An error was detected during reading of SA information (Device		3
		Error	Information)
	83	Drive Parameter SA write	An error was detected during writing of SA information (Device		3
		Error	Information)
	84	Mode Select SA write	An error was detected during writing of SA information (Mode		3
		Error	Select Paramenter)
1A	00	Parameter list length error	There is a mistake in the indication of the parameter list page length.		5
1C	01	Primary defect list not found	The defect list (P List) header is incorrect.		3
	02	Grown defect list not found	The defect list (G List) header is incorrect.		3
	90	SA information list not	The SA information (MODE SELECT parameter) header is		3
		found	incorrect.
1D	00	Miscompare during verify	Comparison of data transferred from the INIT by a VERIFY		E
		operation	command (when the Byte Check mode was specified) with data read
			from the disk media was terminated unsuccessfully.
	80	Miscompare during self-	There is an unmatch to compare read data with write data during		E
		configuration	self-configuration.

*C: Sense Code, Q: Sub-sense Code

C141-E167 5 - 7