Toshiba Installation of the Rotary Cutter for Efficient Performance

4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT

EO18-33027

4.2 ROTARY CUTTER (B-EX204-R-QM-R)

4.2 ROTARY CUTTER (B-EX204-R-QM-R)

WARNING!

Be careful not to injure your fingers when installing the cutter unit.

All the following parts are supplied with the kit. Make sure you have all items shown below.

Description	Q’ty/Unit	Description	Q’ty/Unit
Cutter Unit	1	Cord Bush	1
Cutter Cover	1	Print Head Cleaner	1
Cutter Drive Unit	1	B-SX Cutter Paper Guide	1
Harness Ass’y (2-pin & 9-pin)	1	SM-4x8 Screw	5
Installation Manual	1

NOTES:

1.When using the rotary cutter on the B-E4T series, the print speed of 10”/sec. is not supported. Also, when using the rotary cutter, be sure to install the ribbon saving module (B-EX904-R-QM-R). Failure to do this may cause a paper jam or ribbon error. (For the installation procedure, please refer to Section 4.9.)

2.The B B-EX204-R-QM-Rwith the serial number of 2805Dxxxxxx or earlier cannot be installed on an RFID-ready printer (2804Sxxxxxx or later) without changing some parts of the cutter drive unit. For the parts change procedure, refer to the following:

1)Release the four Locking Supports to remove the Rotary Cutter PC Board from the frame. NOTE: Locking supports are not used. Please discard them.

Frame

Cutter Drive Unit Rotary Cutter PC Board

2) Disassemble the frame into 3 parts.		Rotary Cutter Guide Plate B
	SMW-4x8

SMW-3x6

Rotary Cutter PC Board Cover Rotary Cutter Guide Plate C (To be used later.)

3)Replace the Rotary Cutter Guide Plate B and the Rotary Cutter Guide Plate C with the Rotary Cutter Frame A and Rotary Cutter Frame B, respectively.

4- 4