Toshiba B-EX4 manual Selection Switch

Take-up Spool

4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT

EO18-33027

4.3 PEEL OFF MODULE (B-EX904-H-QM-R)

NOTES: 1. You should change the selection switch setting depending on the issue mode. Improper setting may affect the print quality.

STANDARD/PEEL OFF (STRIP): Batch or strip mode

REWINDER:Built-in rewinder mode For the cut mode, the selection switch can be set to

either position.

Selection Switch

2.The backing paper can be wound directly onto the Take- up Spool or a paper core. When using the Take-upSpool, detach the holder stopper by removing the B-3x4 screw. Otherwise, it may be difficult to pull out the wound backing paper roll. When using a paper core, put the core on the Take-up Spool with the Holder Stopper on it, and attach the top edge of the backing paper to the core with adhesive tape. The Take-up clip is not necessary.

This winding method is applicable to the Built-in Rewinder mode.

Holder Stopper

B-3x4

Screw

Take-up Clip

10)Turn the head lever counterclockwise to Free position.

11)Open the ribbon shaft holder plate.

Ribbon Shaft Holder Plate

Head Lever

Lock position (Label)

Lock position (Tag)

12) Raise the print head block until it stops.

Print Head Block

4-16