Toshiba B-EX4 manual „ LED function, „ Key function, Key Function

6. ON LINE MODE

EO18-33027

6. ON LINE MODE

6. ON LINE MODE

In the ON LINE mode, the following settings can be performed.

Threshold Setting for the Feed Gap Sensor

Threshold Setting for the Black Mark Sensor

Reset

Parameter Settings

Printer Parameter Fine Adjustment

Dump Mode

„LED function

［ON LINE］ＬＥＤ Indicates that the printer is in online condition. Blinks that the printer is communicating with host.

［ERROR］ＬＥＤ Indicates that the printer is in error condition. Blinks when ribbon is in near end condition. Blinks when the system error occurs.

„Key function

Key	Function
[FEED]	(1) Feeds one sheet of paper. This key can be used to eject one sheet of paper.
	This key can also be used to adjust the paper to the proper position when the
	paper is not properly positioned. If printing is attempted when the paper is not
	properly positioned, printing is not performed at the proper position. One or two
	sheets of paper should be fed to adjust the paper position before printing.
	(2) Prints the data in the image buffer on one label according to the system mode
	setting.
	NOTE: A clear command or a command for drawing should not be sent during
	printing by the [FEED] key. If it is sent, the correct layout will be lost, and the
	label will not be printed properly. If an issue is performed by the [FEED] key while
	the data is being drawn in the image buffer, the correct layout may be lost.
	* For the following, refer to the parameter setting section.
	• The procedure for using the label having a label pitches of less than 38 mm in the
	cut issue mode when the disk cutter is used.
	• The procedure for using the label having less than the min. label pitch for each
	issue speed in the cut issue mode when the rotary cutter is used.
	* Feeds label even though there is label at peel off sensor in peel-off mode.

6- 1