Toshiba B-EX4 manual Plunger Head Up Arm Spacer Solenoid SM-4x8 Screw Frame

4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT

EO18-33027

4.4 RIBBON SAVING MODULE (B-EX904-R-QM-R)

4)Secure the RSV PC board to the printer with the locking supports.

RSV PC Board

Holes for securing the RSV PC Board Locking Support

NOTE: Do not push the center of the RSV PC board when attaching it to the printer. Doing so may break the PC board. Hold the locking supports and push them into the holes for securing the RSV PC board.

5)Insert folded tag paper (1.5-mm thick) between the print head and the platen, and then turn the head lever to Lock position. Insert the head up arm into the plunger of the solenoid. While holding down the head up arm slightly, lift the solenoid. Secure the solenoid to the frame with the two SM-4x8 screws keeping the solenoid in contact with the spacer.

Plunger

Head Up Arm

Spacer Solenoid

SM-4x8 Screw

Frame

4-21