Toshiba B-EX4 manual Parameter Settings

5. SYSTEM MODE

EO18-33027

5.3 SELF-DIAGNOSTIC TEST

<< PARAMETER SETTINGS >>

Item	Content		Print value
MEDIA LOAD	Media loading	OFF	Disable
		STD	Feed	detected			gap/mark
			to stop position.
		ECO	Feed	gap/mark				between
			head and sensor to stop
			position.
		ECO+BFeed	Perform		back		feed		after
			completion of ECO.
FORWARD WAIT	Forward feed standby after	ON	Performed
	an issue		(A fine		adjustment				value
			for the stop position is
			also printed.)
		OFF	Not performed
FW/BK ACT.	Forward feed standby action	MODE1	Stops after 13.7-mm
			forward feed.
		MODE2	Stops after 6-mm back
			feed and 3-mm forward
			feed. (Only when the cut
			mode,		thermal			transfer,
			and feed gap sensor are
			selected.) In other cases,
			the	printer		stops			after
			13.7-mm forward feed.
HU CUT/RWD.	Head-up operation in cut	ON	Head-up operation is
	issue mode, or use of the		performed, or the
	rewinder		rewinder is used.
		OFF	Head-up operation is not
			performed,				or		the
			rewinder is not used.
RBN SAVE	Ribbon saving system	ON(TAG)	Used when the head lever
	setting		position is “TAG”
		ON(LBL)	Used when the head lever
			position is “LABEL”.
		OFF	Not used
ＰＲＥ ＰＥＥＬ ＯＦＦ	Pre-peel-off process setting	ON	Pre-peel-off operation is
			performed.
		OFF	Pre-peel-off operation is
			not performed.
ＢＡＣＫ ＳＰＥＥＤ	Back feed speed setting	STD	3ips
		LOW	2ips
AUTO CALIB	Auto calibration setting	OFF	Auto	calibration				is	not
			preformed.
		ON TRANS.	Auto		calibrating				is
			performed						by
			transmissive sensor.
		ON REFLECT	Auto		calibrating				is
			performed			by		reflective
			sensor.
		ON ALL	Auto		calibrating				is
			performed			by			both
			sensor.
		ON	Perform		back		feed		after
		TRANS.+Bfeed	movement				of		ON
			TRANS.

5-8