Toshiba B-EX4 manual Adjust

5. SYSTEM MODE

EO18-33027

5.3 SELF-DIAGNOSTIC TEST

When the power is off, a drive time of 27 seconds or less is rounded down and backed up.

232C ERR RS-232C hardware error count 0 ～ 255

Counts when a parity error or a framing error occurs.

*When data of several bytes is transmitted continuously, counting is performed per byte.

SYSTEM ERR	System error count	0 ～ 15
Counts when a system error occurs.
POWER FAIL	Momentary power interruption count	0 ～ 15

Counts when a momentary power interruption occurs.

<< ADJUST >>

Item	Content	Remark
[PC]FEED	Feed fine adjustment	-50.0mm ～ +50.0mm (*1)
CUT	Cut position (or strip position) fine	-50.0mm ～ +50.0mm (*1)
	adjustment
BACK	Back feed fine adjustment	-9.9mm ～ +9.9mm (*1)
TONE(T)	Print density fine adjustment	-10 ～ +10step
	(Thermal transfer print mode)
TONE(D)	Print density fine adjustment	-10 ～ +10step
	(Direct thermal print mode)
RBN(FW)	Ribbon motor drive voltage fine	-15 ～ +10step
	adjustment (Rewind)
RBN(BK)	Ribbon motor drive voltage fine	-15 ～ +10step
	adjustment (Back tension)
[KEY]FEED	Feed fine adjustment	-50.0mm ～ +50.0mm
CUT	Cut position (or strip position) fine	-50.0mm ～ +50.0mm
	adjustment
BACK	Back feed fine adjustment	-9.5mm ～ +9.5mm
TONE(T)	Print density fine adjustment	-20 ～ +10step
	(Thermal transfer print mode)
TONE(D)	Print density fine adjustment	-20 ～ +10step
	(Direct thermal print mode)
RBN(FW)	Ribbon motor drive voltage fine	-15 ～ +10step
	adjustment (Rewind)
RBN(BK)	Ribbon motor drive voltage fine	-15 ～ +10step
	adjustment (Back tension)
X ADJ.	X-coordinate fine adjustment	-99.5mm ～ +99.5mm
THRESHOLD<R>	Reflective sensor manual threshold	0.0V ～ 4.0V
	fine adjustment
THRESHOLD<T>	Transmissive sensor manual	0.0V ～ 4.0V
	threshold fine adjustment

NOTES: For B-EX4T1-G, “x.3mm” is printed as maintenance counter regardless the selection “x.2 mm” or “x.3mm” since head resolution is 8 dots/mm. The selection of “x.7mm” and “x.8mm” is same manner.

5-7