4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT

EO18-33027

4.2 ROTARY CUTTER (B-EX204-R-QM-R)

15)Attach the cutter cover to the cutter unit with the two screws so that the tab of the cutter cover turns on the cutter cover open switch.

NOTES: 1. Be careful not to pinch the cutter harness by the cutter cover.

2.Make sure that the anti-static brush is protruding from the media outlet.

Cutter Cover

Anti-static

Brush

Media Outlet

Screw

 

Cutter Cover Open Switch

Cutter Cover

Tab

16) Close the print head block and ribbon shaft holder plate.

NOTE: DO NOT excessively push down the print head block to close it. Doing so may cause a failure of the print head block or damage to the print head.

17) Reassemble the side panel (L) and close the top cover. Finally check the cutter operation.

4-11

Page 26
Image 26
Toshiba B-EX4 manual Installation Procedure for Optional Equipment