5. SYSTEM MODE

EO18-33027

5.3 SELF-DIAGNOSTIC TEST

5.3 SELF-DIAGNOSTIC TEST

„Outline of Self-Diagnostic Test

In the Self-Diagnostic Test mode ,the printer checks and prints out the printer system information such as the sensor or interface, and the Maintenance Counter. Also it makes the print head broken element check.

The Self-Diagnostic Test contains the following sub menus:

DIAG. menu item list

MENU ITEM

System Mode / SYSTEM MODE <1>Diagnostics / <1>DIAG.

Counter, Parameter / MAINTENANCE CONT

Auto Diagnostics / AUTO DIAGNOSTIC

Head broken dot check / HEAD CHECK

5.3.1 Counter, Parameter/ MAINTENANCE COUNT

The MAINTENANCE COUNT print procedure of DIAG. is described.

The menu layer from DIAG. to MAINTENANCE COUNT is below.

MENU ITEM

System Mode / SYSTEM MODE <1>Diagnostics / <1>DIAG.

Counter, Parameter / MAINTENANCE CONT

Print method / PRINT TYPE

Thermal transfer / TRANSFR

Direct thermal / DIRECT

Cut type / CUT TYPE

Disable / OFF

Enable / ON

Print/ CHECKING & PRINT

If error occur during printing, the error message is displayed, the error LED turns on and the onlineLED turns off. The erro can be canceled by [ENTER], [CANCEL] or [MODE] key, but printer did not perform re^printing.

5-3

Page 51
Image 51
Toshiba B-EX4 manual SELF-DIAGNOSTIC Test, DIAG. menu item list, Menu Item