HP J7949E manual Telnet Commands and Parameters 12, AppleTalk Command Description

Table 3.4 Telnet Commands and Parameters (12 of 13)

AppleTalk

Command	Description
appletalk	Enables or disables AppleTalk (EtherTalk) protocol
	operation on the print server. 0 disables, 1 (default) enables.
	For example,
	appletalk 0 will disable AppleTalk operation
Name	(Read-only parameter) The name of the printer on the
	AppleTalk network. A number after the name indicates that
	there are multiple devices with this name, and this is the Nth
	instance of the name.
Print Type	(Read-only parameter) Specifies the AppleTalk network
	printer type reported by the Jetdirect print server. Up to three
	print types may be reported.
Zone	(Read-only parameter) The name of the AppleTalk network
	zone on which the printer is located.
Phase	(Read-only parameter) AppleTalk phase 2 (P2) is
	preconfigured on the HP Jetdirect print server.
Status	(Read-only parameter) Indicates the current AppleTalk
	configuration status.
	READY: Indicates the HP Jetdirect print server is awaiting
	data.
	DISABLED: Indicates that AppleTalk was manually
	disabled.
	INITIALIZING: Indicates that the print server is registering
	the node address or name. An additional status message
	may also be displayed.
DLC/LLC
Command	Description
dlc/llc-config	Enables or disables DLC/LLC protocol operation on the print
	server. 0 disables, 1 (default) enables. For example,
	dlc/llc-config 0 will disable DLC/LLC operation.
strict-8022	Controls DLC/LLC protocol interpretation:
	0 (default): disables, that is, provides loose interpretation.
	1: enables, that is, provides strict interpretation).

ENWW TCP/IP Configuration 84