HP J7949E TCP/IP Protocol Information, TCP/IP Configuration Information 1, Host Name, IP Address

TCP/IP Protocol Information

Information in this section of the Jetdirect configuration page is described in Table 9.4. For error messages, see Table 9.9.

Table 9.4	TCP/IP Configuration Information (1 of 4)
Message		Description
STATUS:		Current TCP status.
		READY: Indicates the HP Jetdirect print server is awaiting
		data over TCP/IP.
		DISABLED: Indicates that TCP/IP was manually disabled.
		INITIALIZING: Indicates that the print server is searching
		for the BOOTP server, or trying to get the configuration file
		through TFTP. An additional status message may also be
		displayed.
		An error code and message is displayed if the print server
		is not ready. For more information, see Table 9.9.
HOST NAME:		The host name configured on the print server. It may be
		truncated.
		NOT SPECIFIED: Indicates that no host name was
		specified in a BOOTP response or TFTP configuration file.
		NPIxxxxxx: The default name is NPIxxxxxx, where xxxxxx
		represents the last six digits of the LAN hardware (MAC)
		address.
IP ADDRESS:		The Internet Protocol (IP) address assigned to the
		HP Jetdirect print server. This is a required entry for
		operation of the print server on a TCP/IP network. During
		initialization, a temporary value 0.0.0.0 is displayed. After
		two minutes, a default IP address 169.254/16 or
		192.0.0.192 is assigned.
		NOT SPECIFIED: Indicates that an IP address is not
		assigned or the value is zero.
SUBNET MASK:		The IP subnet mask configured on the HP Jetdirect print
		server. During initialization, a temporary value 0.0.0.0 is
		displayed. Depending on configuration parameters, the
		print server may automatically assign a usable default
		value.
		NOT SPECIFIED: Indicates that a subnet mask is not
		configured.

ENWW HP Jetdirect Configuration Page 185