HP J7949E manual Telnet Commands and Parameters 9, TCP/IP Diagnostics Command Description

Table 3.4 Telnet Commands and Parameters (9 of 13)

dhcp-fqdn-config	Specifies configuration control of the Fully Qualified Domain
dhcp-fqdn-behavior	Name (FQDN), using either DHCP, manual configuration,
	or both. The fully qualified domain name consists of the
	device’s host name and domain name. Select one of the
	following command values:
	0 (default): DHCP may be used to supply the host name and
	domain name. The host name may be changed using a
	manual configuration method (such as the embedded Web
	server, printer control panel, or Telnet). However, the
	domain name cannot be manually changed if it was
	configured through DHCP.
	1: Keep DHCP settings only. Once the Fully Qualified
	Domain Name is configured through DHCP, manual
	changes cannot be made.
	2: Keep manual settings. The settings can be manually
	configured. DHCP may be used only if the settings are
	factory-default values.
	3: Keep manual settings only. While manual configuration
	methods may be used, configuration through DHCP is not
	allowed.
TCP/IP Diagnostics
Command	Description
Last Config IP	(Read-only parameter) The IP address of the system from
	which the HP Jetdirect print server’s IP address was
	configured.
TCP Conns Refused	(Read-only parameter) The number of client TCP
	connections that are refused by the print server.
TCP Access Denied	(Read-only parameter) The number of times that client
	systems were denied access to the print server because
	there was no allowable entry in the print server’s host access
	list.
DHCP Lease Time	(Read-only parameter) DHCP IP address lease duration
	time (seconds).
DHCP Renew Time	(Read-only parameter) DHCP T1 timeout, specifying the
	DHCP lease renewal time (seconds).
DHCP Rebind Time	(Read-only parameter) DHCP T2 timeout, specifying the
	DHCP lease rebind time (seconds).

ENWW TCP/IP Configuration 81