HP J7949E manual Tftp Configuration File Parameters 8

Table 3.3 TFTP Configuration File Parameters (8 of 10)

auth-trap:

(authentication-trap:)

Configures the print server to send (on) or not send (off) SNMP authentication traps. Authentication traps indicate that an SNMP request was received, but the community name check failed. The default is “on.”

trap-dest:

(trap-destination:)

Enters a host’s IP address into the HP Jetdirect print server’s SNMP trap destination list. The command format is:

trap-dest: ip-address[community name] [port number]

The default community name is ”public”; the default SNMP port number is ”162”. The port number cannot be specified without a community name.

If a ”trap-community-name” command is followed by ”trap-dest” commands, the trap community name will be assigned to those entries unless a different community name is specified in each ”trap-dest” command.

To delete the table, use ”trap-dest: 0”.

If the list is empty, the print server does not send SNMP traps. The list may contain up to three entries. The default SNMP Trap Destination List is empty. To receive SNMP traps, the systems listed on the SNMP trap destination list must have a trap daemon to listen to those traps.

IPX/SPX

ipx-config:

(ipx/spx:)

Enables or disables IPX/SPX protocol operation on the print server: 0 disables, 1 (default) enables.

ipx-unit-name:

A user-assigned alphanumeric name assigned to the print server (31 characters maximum). By default, the name will be NPIxxxxxx, where xxxxxx are the last six digits of the LAN hardware address.

ipx-frametype:

Specify the IPX frame type setting available for your print server model: AUTO (default), EN_SNAP, EN_8022, EN_8023, EN_II, TR_8022, TR_SNAP.

ipx-sapinterval:

Specifies the time interval (1 to 3600 seconds) that the HP Jetdirect print server waits between Service Advertising Protocol (SAP) broadcasts on the network. The default is 60 seconds. 0 disables SAP broadcasts.

ipx-nds-tree:

Identifies the name of the Novell Directory Services (NDS) tree for this printer.

ENWW TCP/IP Configuration 53