HP J7949E manual Error Messages 9

Table 9.9 Error Messages (9 of 10)

Error Code and	Description
Message
52 BAD BOOTP/DHCP	An error was detected in the BOOTP or DHCP reply that the
REPLY	HP Jetdirect print server received. The reply either had
	insufficient data in the UDP datagram to contain the
	minimum BOOTP/DHCP header of 236 bytes, had an
	operation field that was not BOOTPREPLY(0X02), had a
	header field that did not match the print servers hardware
	address, or had a UDP source port that was not the
	BOOTP/DHCP server port (67/udp).
53 BAD BOOTP	The tagsize in a vendor-specific field in the BOOTP reply
TAG SIZE	is either 0, or greater than the remaining number of
	unprocessed bytes in the vendor-specified area.
54 BOOTP/RARP	The HP Jetdirect print server is currently in the process of
IN PROGRESS	obtaining its basic IP configuration information through
	BOOTP/RARP.
55 BOOTP/DHCP	The HP Jetdirect print server is currently in the process of
IN PROGRESS	obtaining its basic IP configuration information through
	BOOTP/DHCP, and has not detected any errors.
56 DHCP NAK	The HP Jetdirect print server received a negative
	acknowledgement message from the DHCP server in
	response to a configuration request.
57 UNABLE TO	The HP Jetdirect print server had received IP parameters
CONNECT DHCP SVR	from a DHCP server, but communication with the DHCP
	server has been lost. Check status of the DHCP server.
	If an infinite lease was assigned, the print server will use the
	IP address of the most recent DHCP server used, but
	operation may be degraded until a DHCP server responds.
58 POSTSCRIPT	The printer does not support AppleTalk or AppleTalk
MODE NOT	extensions.
SELECTED
59 INCOMPLETE F/W -	Firmware download message. Currently downloading
MUST DOWNLOAD	firmware to the HP Jetdirect print server, or the download
	did not complete properly.
5A TURN PRINTER	Firmware download message. Download of firmware is
OFF / ON	complete. Power off/on the HP Jetdirect print server.
5C DHCP BAD REPLY	A bad reply was received from the DHCP server. Check your
	DHCP server settings for this print server.
5D DHCP LEASE	The DHCP lease times for this print server’s TCP/IP
DURATION TOO	configuration settings are too short. Reconfigure the DHCP
SHORT	lease times on the DHCP server.

ENWW HP Jetdirect Configuration Page 203