HP J7949E manual Error Messages 10

Table 9.9 Error Messages (10 of 10)

Error Code and	Description
Message
5E DHCP LEASE	The lease for DHCP-configured parameters, including the
RELEASED	IP address, have been released through a manual
	configuration method, such as through the printer’s control
	panel.
5F WINS	Attempts to register the print server’s name on the WINS
REGISTRATION	server failed. Check for duplicate names, or verify the WINS
FAILED	server configuration.
61 AUTO IP	An IP address could not be retrieved over the network. The
CONFIGURED	print server will default to an IP address using link-local
	addressing in the form 169.254.x.x.
62 DEFAULT IP	An IP address could not be retrieved over the network.
CONFIGURED	The print server will default to a legacy default IP address
	192.0.0.192.
63 AUTO IP IN	The print server is automatically assigning an IP address
PROGRESS	using link-local addressing in the form 169.254.x.x.
64 INVALID	An invalid password was specified through TFTP. Verify that
PASSWORD	the password consists of a maximum of 16 printable
	characters.
83 DISCONNECTING	The server has been shut down because of a configuration
FROM SERVER	change or reset request. This message automatically clears
	after a few seconds, unless the printer is offline, is in an error
	state, or is servicing another I/O port or another network
	protocol.
84 DHCP LEASE	The print server detected a DHCP lease error due to one of
TIMERS ADJUSTED	the following conditions:
	● Renew time is less than 30 seconds.
	● Rebind time is less than 52 seconds.
	● Rebind time is less than, or equal to, the Renew time.
	● The lease duration is less than, or equal to,
	the Rebind time.
F1 TRYING TO	The HP Jetdirect print server is trying to connect to the
CONNECT TO	NetWare server(s). This is a normal message. Wait until
SERVER	either the connection is established or another status
	message appears.
F2 TFTP IN	The print server is attempting to use TFTP to obtain TCP/IP
PROGRESS	configuration settings over the network.
F3 BOOTP/RARP IN	The print server is attempting to use BootP or RARP to
PROGRESS	obtain TCP/IP configuration settings over the network.
F4 BOOTP/DHCP IN	The print server is attempting to use BootP or DHCP to
PROGRESS	obtain TCP/IP configuration settings over the network.

ENWW HP Jetdirect Configuration Page 204