HP J7949E manual Command Line Interface Default

Command Line Interface (Default)

Using the Telnet command line interface, you can set configuration parameters using the following procedures:

Note	During a Telnet session, enter ? to view available
	configuration parameters, the correct command
	format, and a list of commands.
	To list additional (or advanced) commands, enter
	the command advanced befored entering ?.
	To display current configuration information,
	enter /.

1.At the Telnet prompt “>” type:

<parameter>: <value>

then press Enter, where <parameter> refers to the configuration parameter you are defining, and <value> refers to the definitions you are assigning to that parameter. Each parameter entry is followed by a carriage return.

See Table 3.4 for configuration parameters .

2.Repeat the previous step to set any additional configuration parameters.

3.When you have finished typing the configuration parameters, type exit or quit (depending on your system).

When prompted whether to save settings that you have changed, enter Y (default) for Yes, or N for No.

If you enter save instead of exit or quit, you will not be prompted to save settings.

ENWW TCP/IP Configuration 72