Table 3.4 Telnet Commands and Parameters (7 of 13)

mdns-pri-svc

Specifies the mDNS highest priority service to use for

 

printing.To set this parameter, choose one of the following

 

printing option numbers:

 

1: Port 9100 printing

 

2: IPP port printing

 

3: The default LPD raw queue

 

4: The default LPD text queue

 

5: The default LPD auto queue

 

6: The default LPD binps (binary postscript) queue

 

7 through 12: If user-specified LPD queues are defined,

 

corresponds to user-specified LPD queues 5 through 10.

 

The default selection will depend on the printer, typically port

 

9100 printing or LPD binps.

 

 

ttl-slp

Specifies the IP multicast “Time To Live” (TTL) setting for

 

Service Location Protocol (SLP) packets. The default value

 

is 4 hops (the number of routers from the local network).

 

The range is 1-15. When set to a -1, multicast capability

 

is disabled.

 

 

ipv4-multicast

Enables or disables the receipt and transmission of IP

 

version 4 multicast packets by the print server. 0 disables,

 

1 (default) enables.

 

 

idle-timeout

An integer (1..3600) that specifies the number of seconds

 

an idle print data connection is allowed to remain open. For

 

example,

 

idle-timeout 120

 

assigns 120 seconds as the desired idle timeout value.

 

The default is 270 seconds. If set to 0, the connection will

 

not terminate and other hosts will not be able to make a

 

connection.

 

 

user-timeout

An integer (1..3600) that specifies the number of seconds

 

that your Telnet or FTP session can be idle before it will be

 

automatically disconnected. The default is 900 seconds.

 

0 disables the timeout.

 

CAUTION: Small values, such as 1-5, may effectively

 

disable the use of Telnet. A Telnet session may terminate

 

before any changes can be made.

 

 

cold-reset

Sets TCP/IP factory default settings. After a cold reset,

 

power cycle the print server. Parameters for other

 

subsystems, such as IPX/SPX or AppleTalk, are not

 

affected.

 

 

ews-config

Enables or disables the print server’s embedded Web

 

server. 0 disables, 1 (default) enables.

 

For more information, see Chapter 4.

 

 

web-refresh

Specifies the time interval (1 -99999 seconds) for embedded

 

Web server diagnostic page updates. If set to 0, the refresh

 

rate is disabled.

 

 

ENWW

TCP/IP Configuration 79

Page 79
Image 79
HP J7949E manual Telnet Commands and Parameters 7