HP J7949E manual HP Jetdirect Configuration 2

Table 9.1	HP Jetdirect Configuration (2 of 2)
Message		Description
PORT CONFIG:		Identifies the link configuration of the RJ-45 port on the
		HP Jetdirect 10/100Base-TX print server:
		10BASE-T HALF: 10 Mbps, half-duplex
		10BASE-T FULL: 10 Mbps, full-duplex
		100TX HALF: 100Mbps, half-duplex
		100TX-FULL: 100Mbps, full-duplex
		UNKNOWN: The print server is in an initialization state.
		DISCONNECTED: A network connection has not been
		detected. Check network cables.
AUTONEGOTIATION		Identifies whether IEEE 802.3u Autonegotiation on the
		HP Jetdirect 10/100TX port is enabled (ON) or disabled
		(OFF).
		ON (default): The HP Jetdirect print server will attempt to
		automatically configure itself onto the network at the proper
		speed (10 or 100 Mbps) and mode (half or full duplex).
		Autonegotiation is enabled after a cold reset.
		OFF: You must manually configure the speed and mode
		using the Jetdirect integrated menu from the printer’s control
		panel. If Autonegotiation is off, the settings must match
		those of the network for proper operation.
MANUFACTURING ID:		The manufacturing identification code for use by HP online
		support personnel.
DATE		Identifies the date of manufacture of the HP Jetdirect print
MANUFACTURED:		server.

ENWW HP Jetdirect Configuration Page 181