HP J7949E manual Miscellaneous Settings 2

Table 4.5	Miscellaneous Settings (2 of 4)
Item		Description
Link settings		(For wired 10/100TX networks only) Set the network link
		speed(10 or 100 Mbps) and communication mode (full- or
		half-duplex) for HP Jetdirect 10/100TX print servers. The
		available settings are listed below.
		CAUTION: If you change the link setting, network
		communications with the print server and network device may
		be lost.
		● AUTO: (Default) The print server uses autonegotiation to
		match the network’s link speed and communication mode. If
		autonegotiation fails, 100TXHALF is set.
		● 10TXFULL: 10 Mbps, full-duplex operation
		● 10TXHALF: 10 Mbps, half-duplex operation
		● 100TXFULL: 100 Mbps, full-duplex operation
		● 100TXHALF: 100 Mbps, half-duplex operation
Primary DNS		Specify the IP address of the primary DNS (Domain Name
Server		System) server.
Secondary DNS		Specify the IP address of a secondary DNS server to use if the
Server		primary DNS server is unavailable.
Scan Idle Timeout		Specifies the number of seconds that an idle connection for
		scanning is allowed to remain open. The maximum is 3600, and
		the default is 300. If set to 0, the timeout is disabled and the
		connection will remain open until closed by the network system
		that is accessing the device.
Locally		Specifies a locally administered address (LAA) that replaces the
Administered		factory-assigned LAN Hardware (MAC) address. If LAA is used,
Address		a user-specified string of exactly 12 hexadecimal digits must be
		entered.
		For Ethernet print servers, the LAA address must start with
		hexadecimal X2, X6, XA, or XE, where X is any hexadecimal digit
		0 through F.
		The default address is the factory assigned address.
Syslog Facility		Specify the encoded source facility of a message (for example,
		to identify the source of selected messages during
		troubleshooting). By default, the HP Jetdirect print server uses
		LPR as the source facility code, but local user values of local0
		through local7 can be used to isolate individual or groups of print
		servers.

ENWW Using the Embedded Web Server 105