HP J7949E manual User Interface Options

To set configuration parameters, you must set up a Telnet session from your system to the HP Jetdirect print server.

1.Type the following at the system prompt: telnet <IP address>

where <IP address> is the IP address listed on the Jetdirect configuration page. See Chapter 9.

2.A connection to the HP Jetdirect print server will be displayed. If the server responds with “connected to IP address”, press Enter twice to make sure that the Telnet connection is initialized.

3.If prompted for a user name and password, enter the correct values.

By default, the Telnet interface does not require a user name or password. If an administrator password has been set, you will be prompted for a user name and this password before you can enter and save Telnet command settings.

4.By default, a Command Line interface is provided. To configure parameters using a Menu interface, enter Menu. For more information, see “User Interface Options”.

For a list of supported commands and parameters, see “Telnet Commands and Parameters”.

User Interface Options

The HP Jetdirect print server provides two interface options to enter Telnet commands: a Command Line Interface (Default) and a Menu Interface.

ENWW TCP/IP Configuration 71