Disney T3260, R2510 owner manual Battery Installation, Battery Connector Battery Retainer

Page 13

BATTERY INSTALLATION

IMPORTANT! Use only a Power Wheels® 6 volt (4.0 Amp/Hr.) battery and built-in thermal fuse. Use of any other battery will damage your vehicle. Make sure that you charge the battery for at least 18 hours using the enclosed Power Wheels® 6 volt (4.0 Amp/Hr.) charger before operating your vehicle for the first time. Charge the battery for at least 14 hours after each use of the vehicle. Never charge the battery longer than 30 hours. Failure to follow these instructions may damage your battery and will void your warranty.

 

 

 

 

 

 

 

 

 

 

1

 

 

LOCKED

UNLOCKED

 

 

 

 

 

Locate the lock fasteners on the front edge of the seat.

Using a slotted screwdriver, turn both lock fasteners ¼ turn to the unlocked position .

2

• Grasp under the front of the seat and lift firmly to remove it.

Battery Connector

Battery Retainer

3

Remove the #8-18 x ⅞" screw from the battery retainer. Lift to remove the battery retainer from the vehicle.

Place the Power Wheels® 6 Volt (4.0 Amp/Hr.) battery in the battery compartment. Make sure the battery connector extends toward the rear of the vehicle.

Replace the battery retainer over the battery. Insert the #8-18 x ⅞" screw through the battery retainer and into the vehicle. Tighten the screw.

4

• Plug the battery connector into the motor harness connector.

Note: If the battery connector will not plug into the motor harness connector, turn it over and try again! Do not force the battery connector into the motor harness connector.

Re-assemble the seat to the vehicle. Using a slotted screwdiver, turn the lock fastener ¼ turn to the locked position .

IMPORTANT! Always remember to keep the lock fasteners locked at all times to prevent children from accessing the battery.

T3260pr-0920

13

 

 

Image 13
Contents For Model R2510T3260 With Assembly InstructionsImportant Information Table of ContentsElectrical Hazard Parts Parts Picture Turn Signal Seat Belt Volt Charger Assembly Tool Dash Key#8 x ¾ Screw Please call Battery ChargingCharger ConnectorBattery Battery Charging AssemblyDash Key Insert two #8 x ¾ screws Dash Wire ConnectorStraight into the dash, as Shown. Tighten the screws Steering ColumnMotor Harness Connector Steering Wheel Steering Wheel Wire with Connector Turn SignalLock Nut End of Steering Column Steering Linkage Steering Column CoverSeat Belt Fasteners Folded Tab Folded End End of Steering Column Lock NutLimited Warranty Assembly Vehicle CareHandle Latch Decoration Battery Connector Battery Retainer Battery InstallationCare Battery Care and DisposalSafe Driving Rules Teach Safety Rules to ChildrenStage 1 Parent Assisted Vehicle OperationProblem Possible Cause Solution Problems and Solutions GuideThermal fuse. Do not substitute parts More than one rider at one time, exceeding the 40 lb Before first-time use You must charge the battery Hours