ASSEMBLY
Lock Nut
End of Steering
Column
Steering Linkage
5 |
•Fit the end of the steering column through the hole in the steering linkage.
•Fit a lock nut onto the end of the steering column.
•Tighten the lock nut with the assembly tool.
Steering Column Cover
6
•Place the steering column cover over the lock nut and push to "snap" it into the steering linkage.
•Turn the vehicle upright.
Steering Wheel 
Wire with Connector
Turn Signal
7
•Position the turn signal with the hollow side down.
•Fit the wire with connector on the end of the steering wheel through the center of the turn signal.
•Fit the turn signal onto the steering wheel.
Motor Harness
Connector
Steering Wheel
Connector
8DASH VIEW
•Plug the motor harness connector from the vehicle into the steering wheel connector.
Steering
Column
9
•While carefully feeding the wire down into the dash, fit the steering wheel onto the end of the steering column.
9 | |
|
|