Fisher-Price M0411 End of Steering Column, Fit the remaining .345 cap nut onto the end

Page 10

F			ASSEMBLY
				End of Steering Column
				Cap Nut
				10
	8	DASH VIEW		• Fit the remaining .345 cap nut onto the end
		DASH VIEW

	• Plug the motor harness connector from the vehicle into the steering			of the steering column.
				• Tap the cap nut with a hammer to secure it to the end of the
	wheel connector.
	wheel connector.			steering column.
				steering column.
				Steering
				Wheel Cap

11

9		• “Snap” the steering wheel cap into the center of the steering wheel.
9

•While carefully feeding the wire down into the dash, fit the steering wheel onto the end of the steering column.

10	M0411pr-0920

Image 10

Contents With Assembly Instructions For Model M0411Table of Contents Important InformationElectrical Hazard Steering Column Handle Seat Belts Vehicle Volt BatteryParts SeatParts Picture Steering Column HandleBattery Charging Your batteryCharger ConnectorBattery Battery Charging AssemblyInsert and snap the key into the dash Screws Steering ColumnEnd AssemblyfSteering Wheel Wire with Connector Turn Signal Cap Nut CoverSteering column End of Steering ColumnFit the remaining .345 cap nut onto the end SteeringSeat Belt Fasteners Loops Handle LatchPlace the labels exactly as shown in the illustrations Limited WarrantyDecoration Vehicle Care To ensure that your vehicle stays in good operating orderBattery Installation Battery Connector Battery RetainerBattery Care and Disposal BatterySafe Driving Rules Always sit on the seat Always wear shoesStore the handle in a safe, clean place for future use Vehicle OperationProblems and Solutions Guide Problem Possible Cause SolutionButton on the handlebar and wait approximately More than one rider at one time, exceeding the 40 lb Before first-time use You must charge the battery Hours