Fisher-Price M0411 owner manual Screws, Steering Column

Page 8

F

 

ASSEMBLY

 

 

 

Dash

 

 

 

3 DASH VIEW

Pull

 

 

• Insert two #8 x ¾" screws straight into the dash, as shown. Tighten

 

 

the screws.

 

 

 

Hint: If the screw holes in the dash do not align with the vehicle, place

 

 

a finger in the steering wheel opening in the dash. Pull the dash toward

 

 

the back of the vehicle to reposition it.

 

 

 

Steering Column

 

 

2

SIDE VIEW

 

 

 

 

Locate the wire connector inside the front end of the vehicle.

While feeding the wire connector through the hole in the dash, fit the

tabs on the dash onto the front end of the vehicle.

4

BOTTOM VIEW

 

• Turn the vehicle over.

• Fit the straight end of the steering column down through the hole in the dash.

8

M0411pr-0920

 

 

Image 8
Contents With Assembly Instructions For Model M0411Table of Contents Important InformationElectrical Hazard Volt Battery PartsSteering Column Handle Seat Belts Vehicle SeatParts Picture Steering Column HandleBattery Charging Your batteryInsert and snap the key into the dash Battery Charging AssemblyCharger ConnectorBattery Screws Steering ColumnAssemblyf Steering Wheel Wire with Connector Turn SignalEnd Cap Nut CoverEnd of Steering Column Fit the remaining .345 cap nut onto the endSteering column SteeringSeat Belt Fasteners Loops Handle LatchLimited Warranty Decoration Vehicle CarePlace the labels exactly as shown in the illustrations To ensure that your vehicle stays in good operating orderBattery Installation Battery Connector Battery RetainerBattery Care and Disposal BatterySafe Driving Rules Always sit on the seat Always wear shoesStore the handle in a safe, clean place for future use Vehicle OperationProblems and Solutions Guide Problem Possible Cause SolutionButton on the handlebar and wait approximately More than one rider at one time, exceeding the 40 lb Before first-time use You must charge the battery Hours