Fisher-Price M0411 owner manual Battery Charging, Your battery

Page 6

E

BATTERY CHARGING

 

 

ELECTRICAL HAZARD

WARNING

Battery can fall out and injure a child if vehicle tips over. Always use battery retainer.

PREVENT FIRE

-Never modify the electrical system. Alterations could cause a fire resulting in serious injury and could also ruin the electrical system.

-Use of the wrong type battery or charger could cause a fire or explosion resulting in serious injury.

-Use of Power Wheels® components in products other than Power Wheels® vehicles could cause overheating, fire or explosion.

The battery must be handled by adults only. The battery is heavy and contains sulfuric acid (electrolyte). Dropping the battery could result in serious injury.

Never allow children to charge the battery. Battery charging must be done by adults only. A child could be injured by the elec-tricity involved in charging the battery.

Never lift or carry the battery by the wires or connector. This can damage the battery and possibly cause a fire resulting in serious injury. Lift and carry the battery by the case only.

Read the safety instructions on the battery.

Examine the battery, charger and their connectors for excessive wear or damage each time you charge the battery. If damage or excessive wear is detected, do not use the charger or the battery until you have replaced the worn or damaged part.

CAUTION

Use the charger in dry locations only.

About Thermal Fuses

Your Power Wheels 6 volt (4.0 Amp/Hr.) battery is equipped with

a built-in thermal fuse. The thermal fuse is a self-resetting safety device which automatically “trips” and shuts down operation of the vehicle

if the vehicle is overloaded or the driving conditions too severe. Once a fuse has “tripped”, release the button on the handlebar and wait approximately 25 seconds before operating the vehicle again. To avoid repeated automatic shut-downs, do not overload the vehicle by exceeding the 40 lbs (18 kg.) maximum weight capacity or by towing anything behind the vehicle. Avoid severe driving conditions, such as driving up slopes or running into fixed objects, which can cause the wheels to stop spinning while power is still being supplied to the motors.

If a thermal fuse in a battery continually trips under normal driving conditions, please contact your local Power Wheels® Authorized Service Center. For the location of the Authorized Service Center nearest to you, visit us on-line at www.powerwheels.com, or call 1-800-348-0751.

Important Notes

Your new battery must be charged for at least 18 hours before you use it in your vehicle for the first time.

We recommend that you start charging your battery before beginning assembly of your new vehicle.

The battery must be upright while charging.

The charger is not a toy.

Do not short circuit the battery.

You do not need to remove the battery from your vehicle to recharge it.

Before charging the battery, examine the battery case for cracks and other damage which may cause sulfuric acid (electrolyte) to leak during the charging process. If damage is detected, do not charge the battery or use it in your vehicle. Battery acid is very corrosive and can cause severe damage to surfaces it contacts.

Do not charge the battery on a surface (such as a kitchen counter top) which could be damaged by the acid contained inside the battery. Take precautions to protect the surface on which you charge

your battery.

Use only a Power Wheels® 6 volt (4.0 Amp/Hr.) charger (input 120 VAC 60 Hz 6W) with an output of 6 VDC 2.4W (400 mA) to charge your Power Wheels® 6 volt (4.0 Amp/Hr.) battery.

Adults Note: Regularly examine the charger for damage to the cord, plug, housing or other parts that may result in the risk of fire, electric shock or injury. In the event of any damage, do not use the charger until the damage has been properly repaired. Please call 1-800-348-0751.

If your battery is old and will not accept a charge, do not leave it in the vehicle. Always remove a dead battery from the vehicle.

6

M0411pr-0920

 

 

Image 6
Contents With Assembly Instructions For Model M0411Table of Contents Important InformationElectrical Hazard Steering Column Handle Seat Belts Vehicle Volt BatteryParts SeatParts Picture Steering Column HandleBattery Charging Your batteryBattery Charging Assembly Charger ConnectorBatteryInsert and snap the key into the dash Screws Steering ColumnEnd AssemblyfSteering Wheel Wire with Connector Turn Signal Cap Nut CoverSteering column End of Steering ColumnFit the remaining .345 cap nut onto the end SteeringSeat Belt Fasteners Loops Handle LatchPlace the labels exactly as shown in the illustrations Limited WarrantyDecoration Vehicle Care To ensure that your vehicle stays in good operating orderBattery Installation Battery Connector Battery RetainerBattery Care and Disposal BatterySafe Driving Rules Always sit on the seat Always wear shoesStore the handle in a safe, clean place for future use Vehicle OperationProblems and Solutions Guide Problem Possible Cause SolutionButton on the handlebar and wait approximately More than one rider at one time, exceeding the 40 lb Before first-time use You must charge the battery Hours