Fisher-Price M0411 Assemblyf, End, Cap Nut Cover, Steering Wheel Wire with Connector Turn Signal

Page 9

ASSEMBLYF

End of

Cap Nut

 

Steering Column

5

 

Fit the end of the steering column through the hole in the steering linkage.

Fit a cap nut on the end of the steering column.

Tap the cap nut with a hammer to secure it to the end of the steering column.

Hint: You may need the help of another adult to hold the steering column in place while you tap the cap nut.

Cap Nut Cover

6

“Snap” the cap nut cover over the cap nut and into the steering linkage.

Turn the vehicle upright.

Steering Wheel

Wire with Connector

Turn Signal

7

Position the turn signal with the hollow side down.

Fit the wire with connector on the end of the steering wheel through the center of the turn signal.

Fit the turn signal onto the steering wheel.

M0411pr-0920

9

 

 

Image 9
Contents For Model M0411 With Assembly InstructionsImportant Information Table of ContentsElectrical Hazard Parts Volt BatterySteering Column Handle Seat Belts Vehicle SeatSteering Column Handle Parts PictureYour battery Battery ChargingBattery Charging Assembly Charger ConnectorBatteryInsert and snap the key into the dash Steering Column ScrewsSteering Wheel Wire with Connector Turn Signal AssemblyfEnd Cap Nut CoverFit the remaining .345 cap nut onto the end End of Steering ColumnSteering column SteeringHandle Latch Seat Belt Fasteners LoopsDecoration Vehicle Care Limited WarrantyPlace the labels exactly as shown in the illustrations To ensure that your vehicle stays in good operating orderBattery Connector Battery Retainer Battery InstallationBattery Battery Care and DisposalAlways sit on the seat Always wear shoes Safe Driving RulesVehicle Operation Store the handle in a safe, clean place for future useProblem Possible Cause Solution Problems and Solutions GuideButton on the handlebar and wait approximately More than one rider at one time, exceeding the 40 lb Before first-time use You must charge the battery Hours