Fisher-Price P4266 owner manual Rim, Slide a rim, indented side out, onto the front axle

Page 11

Rim

11

• Slide a rim, indented side out, onto the front axle.

13

• Test to be sure the wheel spins. Lift the front end of the vehicle up slightly and turn the wheel. It should spin freely.

• If the wheel does not spin freely, use the assembly wrench to loosen the lock nut a 1/4" turn. Spin the wheel again and loosen more, if necessary.

Lock Nut	Assembly
	Wrench

12

•Fit a lock nut onto the end of the front axle and tighten with the assembly wrench.

IMPORTANT! Fully tighten the lock nut with the included assembly wrench.

Front Hubcap

14

•Fit the tabs on the front hubcap into the slots in the front wheel. Push to "snap" into place.

•Repeat steps 9-14 to assemble the remaining bushing, front wheel, rim and front hubcap to the other front axle.

11	P4266pr-0920

Image 11

Contents With Assembly Instructions For Model P4266 Important Information Table of ContentsElectrical Hazard Parts Part Not Shown Label Sheet 12V BatterySteering Wheel Cap Front Hubcaps Bushings Front Axle Fastener Caps Rear Axle Caps1515 114 Parts PicturePlease call Battery ChargingRear Wheel AssemblyCharger Battery Connector Motor Rear AxleFront Axle Rear Axle CapRear Hubcap Front Wheel Front Axle Fastener CapSlide a rim, indented side out, onto the front axle RimScrew Shock Post SlotLong Seat Belt Folded Tab End Short Seat Belts Rear FendersDo not insert screws here Folded Tab FoldedTabs Sidebar CoverHood Pegs BumperSteering Column Post Bend Slot Hole Assembly WrenchSteering Wheel Cap ScrewsSteering Wheel Steering Column Lock NutDecoration Right Side View Motor Harness Battery InstallationBattery Door Power Wheels Volt BatteryCare Battery Care and DisposalRiding Hazard Safe Driving RulesRemove Vehicle OperationVehicle Care Limited WarrantyProblem Possible Cause Solution Problems and SolutionsWall Operation of the drive system by raising the rear wheels off Before first-time use You must charge the battery Hours